Composite components are often used to make raised-panel cabinet doors. Goods like MDF or “moderate-density-fiberboard” are employed because they will have a regular center which is difficult and when routed, create a smooth, level raised-panel impact. Woodworkers path right to the center with routers designed with raised-panel router bits directed by jigs that manage the dimensions of the panel that was raised. It requires two passes with two router bits that are person to make MDF -panel door. Exactly the same jig can be used on both passes.
Assess the dimensions of the MDF door and cut on a part of 3/4-inch hardwood plywood to the same dimensions on a tablesaw. Place at 2 1/4 inches to the right-side of the blade and lock it . down Lower the blade below the top layer of the dining table.
Draw a 2 2/4-inch margin around the interior of the plywood. Slide the plywood up to to against the fencing. The leading margin line needs to be right on the stage where the blade comes in the table.
Put your hand on the plywood of where the blade comes in the table to the correct side. Turn on the tool. Hold the plywood down tight from the table as you crank the wheel to lift the blade. Shove the plyboard forwards with your hands palms, when the blade comes in the plyboard. Quit shoving when the blade reaches the margin line on the rear of the plywood. Reach down with your right-hand and shut the tool off. Wait before the blade stops and decreases. Lower the blade below the top layer of the dining table.
Revolve the panel 1 / 4 turn at a time and duplicate cutting on every side of the plywood across the margin line, lifting and reducing the blade for each cut. Till the blade stops wait. Pick the plywood up and pop the middle of it outside with your hand, in the event the centre does not fallout alone. This creates a square MDF elevated-panel jig.
Clamp the jig to the do-or utilizing two-hand clamps. Install the initial raised-panel bit right into a layer 3 switch. Run the router throughout the inside margin of the jig to slice the on bead and the channel. Install a 3/8-inch bushing in to the router foundation. The 2nd elevated-panel knife to the router. Run the router across the jig to slice the on the profile that is interior. This finishes the elevated-panel do or.